Table of Contents
Advertisement
HOW TO FIX LEG TO BASE-HOLE FOR
INSTALLATION
• When you install this unit, be sure to
assemble LEGS(4EA) to base
under(Fig.4).
• Place this unit on its rear side on a
carton to prevent damage to the body.
• Insert the leg(4EA) into the base
under hole as it was. By first inserting
its two hooks.
• Turn right and screw on leg.
• Make the allows of leg and base
under face with each other at each
corner.
CAUTION: After installing, DO NOT REMOVE LEGS.
Caution (Only dual voltage model)
• Make sure that the electric connector
is set for your available voltage before
operating the washing machine.
This unit is set for 220V. If you want to
change the voltage, remove the back
cover and reset the connector as a
figure on the right.
HOOK (2EA)
1. Inserting
2. Turn right
3. Screw on.
Figure 4.
CONNECTOR
CONNECTOR
10
PLUG
Advertisement
Table of Contents
