Setting Warmer Drawer Control - Frigidaire 318203860 Use & Care Manual

Setting Warmer Drawer Control

To Set the Warmer Drawer Controls:
The control and indicator lights for the Warmer Drawer features are located on the control panel. The temperatures are
approximate, and are designated by HI (high), MED (medium) and LO (low).
1. Touch the (see Fig. 4) pad at the Warmer Drawer control position. The Warmer Drawer indicator light will flash. Note:
If no further pads are touched within 25 seconds the request to power the Warmer Drawer ON will clear.
2. Set the desired power level. Touch
level for LO (see Fig. 3). The Warmer Drawer indicator light located beside the
3. Each touch of the
2) to LO (see Fig. 3). Note: For best results, preheat the Warmer Drawer before adding the food . An empty drawer will preheat
in approximately 15 minutes.
4. When the food is ready for removal, touch the
The Warmer Drawer indicator light will turn OFF.
Note: The Warmer Drawer is inoperable during the self-clean cycle.
Note: The warmer drawer is equipped with
a latch which may require extra force when
opening and closing the drawer.
once to turn ON the power level for HI (see Fig. 1) or
or pads will decrease or increase through 5 power levels from HI (see Fig. 1) to MED (see Fig.
pad once to turn the Warmer Drawer OFF.
Fig. 1 Fig. 2
17
(If Equipped)
to turn ON the power
pad will turn ON steady.
Fig. 3 Fig. 4