Manual Channel Setting - NEC FS-5170 Instruction Manual

MANUAL CHANNEL SETTING

Press the NUMBER buttons 0..9 or UP/DOWN buttons(CHV/W) to
select the programme number you want.
The screen will change according to the selected programme number.
You can also call up Manual tune at the Install menu.
SEARCHING A CHANNEL (figure 5)
Move the cursor to Manual tune with the UP/DOWN buttons(CHV/W)
and then press the LEFT/RIGHT buttons(VOLC/B).
The tuning screen will appear and the cursor will move from left to right
or from right to left. The channel, will be searched from the band area
of the current programme. If you continuously press the LEFT or
RIGHT button the over 5 seconds, the current band area is shifted to
the next band area.(VHF-L
After searching a station, the tuning screen will disappear.
To stop searching, press the MENU button.
FINE TUNING (figure 6)
If you are unable to get a good picture or sound because of a poor
broadcasting signal, it is possible to adjust the fine tuning.
Move the cursor to Fine tune and press the LEFT/RIGHT buttons
(VOLC/B) to activate fine tuning.
It operates only when the LEFT/RIGHT buttons(VOLC/B) are being
pressed. The changes are memorized automatically.
SELECT SOUND SYSTEM
If you hear strange sound or noise sound, then call up the Edit menu
at the Install menu.
Move the a cursor to below SOUND the LEFT/RIGHT buttons
(VOLC/B).
Select the sound system BG, DK, I with the UP/DOWN buttons(CHV/W),
then sound will be changed automatically .
VHF-H UHF)
7
Install
Auto setup
Manual tune
Fine tune
Edit
Manual tune UHF Pr 01
[Figure 5]
Install
Auto setup
Manual tune
Fine tune
Edit
Fine tune 61.25MHz
[Figure 6]