Frigidaire 318200710 Use & Care Manual page 21

Cleaning Various Parts
of Your Range
Be sure the range is
cool before removing elements or
drip bowls. Be careful not to bend
terminal ends when replacing
elements after cleaning.
(Some Models Only)
When lowering the lift-
up range top, grasp the sides with
finger-tips only. Be careful not to
pinch fingers. DO NOT drop or bend
the range top when raising or
lowering. This could damage the
surface.
Surface Elements and Drip Bowls
Surface elements can be unplugged and removed to make cleaning the drip pans
(continued)
easier. The surface elements clean themselves when they are turned on. Food spilled
on a hot element will burn off. Food spilled on a cool element may be cleaned with
a damp cloth—any remaining soil will burn off the next time the element is used.
Never immerse a surface element in water.
To Remove the Surface Elements and Drip Bowls
1. Lift up edge of surface element across from terminal end. Lift just enough to clear
edge of the drip bowl.
2. Gently slide the surface element out of the terminal plug.
3. Lift the drip bowl up and out.
To Clean Drip Bowls
Wash in hot, soapy water or in the dishwasher. Rinse and dry while still warm. Hard
to remove, burned on soil can be removed by soaking the drip bowls for about 20
minutes in a lightly diluted liquid cleanser or a solution of ammonia and water
(1/2 cup ammonia to 1 gallon of water). A nylon scrubber may be used after soaking.
DO NOT use abrasive cleaners or steel wool, as they will scratch the surface. Always
rinse with clean water and polish dry with a soft cloth.
To Replace Drip Bowls and Surface Elements
1. Slide the terminal end on the element through the opening in the drip bowl.
2. Align the element support to rest on the rim inside the drip bowl. If your drip bowl
is equipped with a hold down clip, align the element support opposite the
terminal end with the slot in the hold down clip, and snap into place.
3. After the element is positioned in the drip bowl, line up the terminal end with the
terminal plug as shown.
4. Hold the surface element and drip bowl together as level as possible and firmly
push the terminal end into the terminal plug. Make sure element terminal is
seated properly into terminal plug. Make sure the surface element is level to
reduce the hazard of pans sliding off the element.
To Raise the Top for Cleaning
1. Grasp the sides and lift from the front. Lift-up rod will support the top in its raised
position. Only lift the top high enough to allow the support rod to rest in place
under the front of the cooktop.
2. Clean underneath using a clean cloth and hot, soapy water.
3. To lower the top, lift the top slightly and lower the rod. Lower the range top into
the range frame.
(Some Models Only)
21