Electrical Connection - AEG FAVORIT 88070 i User Manual

42
Connecting the dishwasher

Electrical Connection

Any electrical work required to install this appliance should be carried out
by a qualified electrician or competent person.
WARNING This appliance must be earthed.
The manufacturer declines any responsibility should these safety meas
ures not be observed.
Before switching on make sure the electricity supply voltage is the same as that
indicated on the appliance rating plate.
To isolate the dishwasher from the mains, remove the mains plug.
Important: The plug must still be accessible after the appliance has been in
stalled.
Changing a fuse
The appliance is supplied with a 13amp plug fitted. In the event of having to
change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse
must be used.
Should the plug need to be replaced for
any reason, proceed as described below.
The wires on the mains lead are coloured in
accordance with the following code.
Green and Yellow:
Blue:
Brown:
• The wire coloured green and yellow must
be connected to the terminal marked
with the letter "E" or by the earth symbol
• The wire coloured blue must be connected to the terminal "N" or coloured
black.
• The wire coloured brown must be connected to the terminal marked "L" or col
oured red.
• Upon completion there must be no cut, or stray strands of wire present and
the cord clamp must be secure over the outer sheath.
WARNING! A cut off plug inserted into a 13 amp socket is a serious safety
(shock) hazard. Ensure that, if it is necessary to cut off the plug, it is dis
posed of safely and not retained.
Earth
Neutral
Live
Green & Yellow
Blue
or coloured green and yellow.
Brown
Cord Clamp