Before Setting Oven Controls - Frigidaire 318205325 Use And Care Manual

BeFore setting oven controls

oven vent location
The oven is vented at the upper control panel and center
trim. When the oven is on, warm air is released through
the vent. This venting is necessary for proper air circulation
in the oven and good baking results.
caution
some models are equipped with a blower which
runs in self-cleaning mode to keep all internal
components at a cool temperature. the blower
may keep running even if the oven has been
turned off, until the components have cooled
down.
air circulation in the oven
If using 1 rack, place in center of oven. If using multiple
racks, stagger cookware as shown.
For best air circulation and baking results allow 2-4" (5-10
cm) around the cookware for proper air circulation and be
sure pans and cookware do not touch each other, the oven
door, sides or back of the oven cavity. The hot air must
circulate around the pans and cookware in the oven for
even heat to reach around the food.
6
ARRANGING OVEN RACKS
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL
(PRIOR TO OPERATING THE OVEN). Always use oven mitts
when using the oven.
To remove an oven rack, pull the rack forward until it
stops. Lift up front of rack and slide out.
To replace an oven rack, fit the rack onto the guides on
the oven walls. Tilt the front of the rack upward and slide
the rack back into place.
RECOMMENDED RACK POSITION
Food
Broiling meats, chicken or fish
Cookies, cakes, pies, biscuits & muffins
Using a single rack
Using multiple racks
Frozen pies, angel food cake, yeast,
bread, 1 or 2 casseroles, small cuts of
meat or poultry
Turkey, roast or ham

note
Always use caution when removing food from the oven.
Rack Position
3 or 4
2 or 3
2 and 4
1 or 2
1
4
3
2
1
Rack
positions