Changing The Light Bulb - AEG Santo 2732-4 i Operating And Installation Manual

Malfunction
Unusual noises.
The compressor does not
start immediately after chan-
ging the temperature set-
ting.
Water on the floor or on sto-
rage shelves.

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the
light bulb, switch off the appliance and unplug it, or pull the fuse or
the circuit breaker. Light bulb data: 220-240 V, max. 15 W
1. To switch off the appliance, turn
the temperature regulator to posi-
tion "0".
2. Unplug the mains plug.
3. To change the light bulb, unscrew
the light cover.
4. Unhook the light bulb cover as
shown.
5. Change the defective light bulb.
6. Refit the light bulb cover and the
screw.
7. Put the refrigerator back into ope-
ration.
16
Possible Cause
Appliance is not level.
The appliance is touching
the wall or other objects.
A component, e.g. a pipe,
on the rear of the appliance
is touching another part of
the appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after
a period of time.
See the "Cleaning and
Care" section.
D731