Configuring Oracle Database And Oracle Net Services For Oracle Dce Integration; Dce Address Parameters - Oracle Database B10772-01 Administrator's Manual

Configuring Oracle Database and Oracle Net Services for Oracle DCE Integration
Configuring Oracle Database and Oracle Net Services for Oracle DCE
Integration
This section describes how to configure an Oracle database server and Oracle Net
Services to use Oracle DCE Integration after it has been successfully installed. It
contains the following topics:

DCE Address Parameters

DCE addresses in the
defined by DCE parameters, illustrated in the following:
ADDRESS=(PROTOCOL=DCE)(SERVER_PRINCIPAL=server_name)(CELL_NAME=cell_name)
(SERVICE=dce_service_name))
These parameters are described by
Table 10–1
Component
PROTOCOL
SERVER_PRINCIPAL
10-8 Oracle Database Advanced Security Administrator's Guide
DCE Address Parameters
Task 1: Configure the Server
Task 2: Create and Name Externally Authenticated Accounts
Task 3: Set up DCE Integration External Roles
Task 4: Configure DCE for SYSDBA and SYSOPER Connections to Oracle
Databases
Task 5: Configure the Client
Task 6: Configure Clients to Use DCE CDS Naming
listener.ora
DCE Address Parameters and Definitions
and
tnsnames.ora
Table 10–1:
Description
A mandatory field that identifies the DCE RPC protocol.
A mandatory field for the server and an optional field for the
client. The server authenticates itself to DCE as this principal.
This field is mandatory in the listener configuration file
(listener.ora) and specifies the principal the server will
start under. This field is optional in your local naming
configuration file (tnsnames.ora) and specifies the principal
of the server the client must connect to. If not specified, then
one-way authentication is used. In this case, the client does not
care what principal the server is running under.
configuration files are