Differential Signals; Sas-2 Specification Compliance; Additional Information - Seagate Constellation ST9500622SS Product Manual
Hide thumbs
Also See for Constellation ST9500622SS:
- Product manual (46 pages) ,
- Product manual (54 pages)
Table of Contents
Advertisement
The Ready LED Out signal is designed to pull down the cathode of an LED. The anode is attached to the
proper +3.3 volt supply through an appropriate current limiting resistor. The LED and the current limiting resis-
tor are external to the drive. See Table 15 for the output characteristics of the LED drive signals.
Table 15:
LED drive signal
State
LED off, high
LED on, low
12.5.2
Differential signals
The drive SAS differential signals comply with the intra-enclosure (internal connector) requirements of the SAS
standard.
Table 16 defines the general interface characteristics.
Table 16:
General interface characteristics
Characteristic
Bit rate (nominal)
Unit interval (UI)(nominal)
Impedance (nominal, differential )
Transmitter transients, maximum
Receiver transients, maximum
12.6
SAS-2 Specification Compliance
Seagate SAS-2 drives are entirely compatible with the latest SAS-2 Specification (T10/1760-D) Revision 16.
The most important characteristic of the SAS-2 drive at 6Gb/s is that the receiver is capable of adapting the
equalizer to optimize the receive margins. The SAS-2 drive has two types of equalizers:
1. A Decision Feedback Equalizer (DFE) which utilizes the standard SAS-2 training pattern transmitted dur-
ing the SNW-3 training gap. The DFE circuit can derive an optimal equalization characteristic to compen-
sate for many of the receive losses in the system.
2. A Feed Forward Equalizer (FFE) optimized to provide balanced receive margins over a range of channels
bounded by the best and worst case channels as defined by the relevant ANSI standard.
12.7
Additional information
Please contact your Seagate representative for SAS electrical details, if required.
For more information about the Phy, Link, Transport, and Applications layers of the SAS interface, refer to the
Seagate SAS Interface Manual, part number 100293071.
For more information about the SCSI commands used by Seagate SAS drives, refer to the Seagate SCSI
Commands Reference Manual, part number 100293068.
68
Test condition
≤
≤
0 V
VOH
3.6 V
I
= 15 mA
OL
Units
Mbaud
ps
ohm
V
V
Output voltage
-100 μA < I
< 100 μA
OH
≤
≤
0
V
0.225 V
OL
1.5Gb/s
3.0Gb/s
1500
3000
666.6
333.3
100
100
± 1.2
± 1.2
± 1.2
± 1.2
Constellation.2 SAS Product Manual, Rev. H
6.0Gb/s
6000
166.6
100
± 1.2
± 1.2
Advertisement
Table of Contents
