Seagate Constellation ST9500622SS Product Manual page 65

Table 7: Supported commands
Command name
Verify (12)
Verify (16)
Verify (32)
Write (6)
Write (10)
DPO bit
FUA bit
Write (12)
Write (16)
Write (32)
Write and Verify (10)
DPO bit
Write and Verify (12)
Write and Verify (16)
Write and Verify (32)
Write Buffer (modes 0, 2, supported)
Write Buffer
Firmware Download option (modes 5, 7, Ah and Bh) [3]
Firmware Download option (modes 4, 5, 7)
Write Long (10)
Write Long (16)
Write Same (10) [5]
PBdata
LBdata
Write Same (16) [5]
Write Same (32)
XDRead
XDWrite
XPWrite
[1] Constellation.2 drives can format to 512, 520 or 528 bytes per logical block.
[2] Warning. Power loss during flash programming can result in firmware corruption. This usually makes the
drive inoperable.
[3] Reference Mode Sense command 1Ah for mode pages supported.
[4] Y = Yes. Command is supported.
N = No. Command is not supported.
A = Support is available on special request.
[5] Approximately 1.5 increase in time to complete this command for a SED drive versus a non-SED drive of
the same capacity.
Constellation.2 SAS Product Manual, Rev. H
Command code Supported
AFh N
AFh Y
7Fh/000Ah N
0Ah Y
2Ah Y
Y
Y
AAh N
8Ah Y
7Fh/000Bh N
2Eh Y
Y
AEh N
8Eh Y
7Fh/000Ch N
3Bh Y (non-SED drives only)
3Bh
Y (non-SED drives only)
Y (SED drives only)
3Fh Y
9Fh/11h Y
41h Y
N
N
93h Y
7Fh/000Dh N
52h N
50h N
51h N
57