Table of Contents
Advertisement
Drive operation and maintenance
Troubleshooting
STT8000A Product Manual
If you experience problems after you install the drive, take the following actions to
try to solve the problems.
1.
Make sure that all cable connections are secure.
2.
Check the drive to be sure that the jumper settings are correct.
If a power interruption occurs during a backup or restore operation, start over when
the power is restored. If the drive appears to fail during a backup or restore
operation, try the following steps:
1.
Remove and replace the cartridge and try again. Make sure you are using the
correct type of tape cartridge.
2.
Turn off all power to the computer and drive. Wait for the computer to power
down and then start over.
3.
Try a different tape—preferably one that has never been used.
4.
Check all cable connections for proper contact.
5.
Clean the tape drive head as previously instructed. Then try the operation
again.
If problems persist, contact your tape drive supplier or Seagate technical support at
US and Canada
Outside US and Canada
Seagate Web Site
Seagate BBS
Before you call technical support, be sure that you have the documentation for your
computer and for all installed peripheral devices.
1-800-SEAGATE (1-800-732-4283)
1-405-936-1234
http://www.seagate.com
1-405-936-1630
Chapter 4
Page 29
Advertisement
Table of Contents
