Siemens SIMATIC Box PC 620 Operating Manual page 2

Safety Guidelines
This operating manual contains notices which you should observe to ensure your own personal safety, as
well as to protect the product and connected equipment. These notices are highlighted in the manual by a
warning triangle and are marked as follows according to the level of danger:
Warning
!
indicates that death, severe personal injury or substantial property damage can result if proper precautions
are not taken.
Danger
!
indicates that minor personal injury or property damage can result if proper precautions are not taken.
Note
draws your attention to particularly important information on the product, handling the product, or to a
particular part of the documentation.
Correct Usage
Please observe the following
Note
You can set up and operate your programming device in conjunction with the following instructions. You
should only connect external devices and work with memory cards in conjunction with the manual SIMATIC
Box PC620. The manual is also available in electronic form on the CD-ROM labeled "Documentation and
Drivers".
Only qualified personnel should be allowed to install and work on this equipment using the manual.
Qualified persons are defined as persons who are authorized to commission, to ground, and to tag
equipment, systems, and circuits in accordance with established safety practices and standards.
Warning
!
This device may only be used for the applications described in the catalog or manual, and only in connec-
tion with devices or components from other manufacturers which have been approved or recommended
by Siemens.
This product can only function correctly and safely if it is transported, stored and set up carefully and
correctly, and operated and maintained as recommended.
Trademarks
SIMATICR SIMATIC NETR and SIMATIC HMIR are registered trademarks of Siemens AG.
E
Copyright Siemens AG 2000 All Rights Reserved
Siemens AG
Bereich Automatisierungs- und Antriebstechnik
Geschaeftsgebiet Industrie-Automatisierungssysteme
Postfach 4848, D-90327 Nuernberg
Exclusion of Liability
E
Siemens AG 2000
Subject to technical change.