CMD-X2000 SERVICE MANUAL AEP Model UK Model SPECIFICATIONS Signalling format GSM PHASE II Frequency range Transmit: 890 ~ 915 MHz Receive: 935 ~ 960 MHz GSM power class Class 4 (2 W) SIM chip Pluggable mini SIM card Display Two-row. resp. four-row full-graphic LCD display + ICON line...
The jog dial (2) The jog dial is important for quick and easy navigation and operation of the CMD-X2000. In idle mode (the network operator name appears on the display), press the jog dial once to activate the phone book. In menus and the standard phone book, rotate the jog dial up or down to scroll through the menu options or phone book and press the jog dial to make a selection.
Page 3
The menu Change the service and phone settings using the menu system of your CMD-X2000 (see also “Menu operations”). Simply press the menu key to select the main menu. Rotate the jog dial to scrolll through the menu options.
Page 4
Simply press the exit key (13) once to go one step back in a menu; press and hold the exit key to exit the menu and return to idle mode. After a lapse of 2 minutes, the CMD-X2000 automatically exits the menu and defaults to idle mode.
SECTION 2 DISASSEMBLY 1. Remove Simcard holder , antenna (no tool needed), 2. Remove 4 screws. battery cover and battery. 3. The back lower case assy and battery plate can now 4. Remove 4 screws from the upper shielding. be separated from the upper case. 5.
Page 6
7. To separate the RF/Logic block from the MMI board, 8. When the spring is taken off, the RF/Logic unit can lift the spring slightly using a small flat screwdriver be lifted. The centre bolt (MMI support) can now also while pushing it to the right with your finger.
SECTION 3 LEVEL 1 TROUBLESHOOTING CHART Insert SIM card Switch on Does the Does the Insert new telephone telephone battery switch on? switch on? Does Does the the original SIM probably telephone SIM card work defective log on? on another set? Is a call...
SECTION 4 PROGRAMMING INSTRUCTIONS 1 Hardware Setup The software programming setup requires a PC (386 type or higher) and the bootadaptor kit. The boot adaptor kit consists of bootadaptor, cables and power supply. Connect RS232 cable from bootadaptor to com-port of PC (com 1 or com 2) Connect power supply (9V) to bootadaptor Connect bootadaptor to CMDX2000 2 Software setup...
SECTION 6 SPARE PARTS AND ACCESSORIES LIST Ref. No. Part Number Description 1-501-941-11 Antenna X-3374-024-1 Case (lower) X-3374-025-1 Plate, battery assy 3-018-366-01 Screw torx 2.0 x 6 3-015-723-01 Screw torx 1.8 x 16 3-015-724-01 Sim holder 3-015-725-01 Cover ringer 1-759-436-21 Ringer 1-475-287-21 Jog dial...
Page 11
English Printed in Belgium Sony Customer Relations & Service Europe 1997.10 9-948-423-10 European Technical Support Published by ETS...