Electrical Connection - Whirlpool 8528095 REV A Installation Instructions Manual

Electrical Connection

WARNING
Electrical Shock Hazard
Electrical earthing is required on this dryer.
Do not earth to a gas pipe.
Do not change the power supply cord plug. If it does
not fit the outlet, have a proper outlet installed by a
qualified electrician.
Do not have a fuse in the neutral or earthing circuit.
Do not use an extension cord with this dryer.
Check with a qualified electrician to be sure the dryer is
properly earthed.
Do not connect plug end of power supply cord into a
live receptacle before connecting power supply cord to
dryer terminal block.
Do not reuse old power supply cord.
Failure to follow these instructions could result in
death, fire, or serious injury.
Plug supply cord into an earthed outlet. It should be connected to
an electricity supply socket at the voltage shown on the rating
plate. The minimum supply fuse capacity should be 16A. The
dryer must be positioned so that the plug is accessible. If the
fitted plug is not used, the electrical connection must be carried
out by a competent electrician in accordance with local or
national codes.
If the supply cord is damaged, it must be replaced with a
specially terminated cord by an authorized service agent or a
similarly competent person.
Do not use an adapter.
Do not use an extension cord.
Important: Observe all governing codes and ordinances.
If codes permit and an additional earth bond wire is used, it is
recommended that a competent electrician determine that the
earth bond path is adequate.
8