Advertisement
most efficient
use from your new
range,
read your Whirlpool
Use&Care
Congratulations!
finished
installing
your
new Whirlpool
ranae.
To aet the
Guide. Keep Installation
Instructions
and Guide
close to range
for easy
reference.
The instructions
will
make
reinstalling
your Whirlpool
h
LX Gas
Conversion
(Electronic
Ignition
and Standing
Pilot Systems)
Converttng to L.P. gos
should be done by
a quaffled
Installer.
Nahml
A
Only a qualified
installer should
n
Install or
adjust your gas range.
Pressure Regulator:
Use a wrench
to
unscrew
the COD from
the top by turning counter-
clockwii.
Turn the cap over so the hole
end is up. Replace
the cop and gasket
on the regutator.
DO NOT REMOVE THE
PRESSURE REGULATOR.
Part No. 76724.CQ/4320880
01990 Whirlpool
Corporation
Burners:
Turn the orifices
hood down
until snug
against
pin. DO NOT OVERTIGHTEN.
Adjust the air shutters for proper
flame
by
sliding the air shutter to close or open the
shutter as needed.
See Panel C, Step 18
for electricul
lgtition
systems or Step 19P
for standing
pllot systems.
Caoktop
burners with standing
pilots
require
adjustment
of pilot flame to l/4'
hlgh.
The adjustment
control
is located
on the manifold
plpe or at pilot ftame
base, depending
on the model,
TKifl
01
2
CORPORAllON
C
'
Oven Burner:
Remove
oven
racks and lower panel
from
oventottom.
Turn the orifice
hood
down
until snug against
pin. DO NOT
OVERTIGHTEN.
The burner flame should
be l/2' long when air shutter is correctly
adjusted
The air shutter slides to close or
open
the shutter OS needed.
See Pane
C, Step 21 for electronic
ignition
systems,
or Step 23A for standing
pilot systems.
Replace
oven bottom
ond rocks.
D
Oven thermostal:
Remove
.
thermostat
knob. pulling straight
off. Use a small screwdriver
to rotate
the
key to L.P. Replace
thermostat
knob.
E
After all the burners have been
converted
to L.P. gas usage and
gas~ne
is connected,
check
for leaks.
Use a brush and liquid detergent
to test
all gas connections
for leaks.
Bubbles
around
connections
will indicate
a
leak. If a leak appears,
shut off gas
valve
controls
and wrench-tighten
connections.
Then check
connections
ogoln.
NEVER TEST FOR GAS LEAKS WITH
A MATCH OR OTHER FLAME.
Prepared
by Whirlpool
Corporation.
Benton
Harbor.
Michigan
49022
Printed in U.S.A
Advertisement
