Vax VZL-801 Instruction Manual page 5

Vax VZL-801 User Guide_Amended.qxd
Starting Up
1. Holding the power cord by the plug, pull cord out
completely. The red tag will indicate the end of the
cord. Plug into the outlet (Fig. 4/2).
Fig.4/2
2. For easier handling while vacuuming, hook the power
cord onto the power cord hook (Fig. 4/3).
Fig.4/3
3. Switch the upright vacuum cleaner on or off by
pressing the on/off switch (Fig. 4/4).
Fig.4/4
22/3/07 2:01 pm Page 5
Brush Vacuuming
1. Tilt the upright vacuum cleaner back before you start
vacuuming. At the same time, use your foot to press
the nozzle down onto the carpet (Fig. 4/5).
Fig.4/5
Brush Vacuuming on carpeted floors:
• The brushbar is switched on or off using the brushbar
on/off switch (Fig. 4/6). Switch brushbar on for carpeted
floors.
Fig.4/6
• The rotating brushbar loosens deeply embedded dirt
and brings it to the surface.
Vacuuming on smooth surfaces:
• Switch brushbar off to obtain the best results when
vacuuming smooth barefloor surfaces.
Brushbar Reset
1. If something becomes lodged and the brushbar shuts
off, turn the cleaner off and remove obstruction. Press
the reset button at the back of the cleaner head to
reset the brushbar motor. (Fig. 4/7).
Fig.4/7
Vax Careline 0870 606 1248
5
how to operate