Table of Contents
Advertisement
JP1: Clear CMOS
Pin_3
Normal
(Default)
Pin_3
Clear CMOS
Onboard ID LED
You can identify the specific system using this LED. Users from remote
site could also activate ID LED by input a few commands in IPMI,
detailed software support please visit
AST2050 user guide.
+
-
You can reset the CMOS settings by using this
jumper if you have forgotten your system/setup
Pin_1
password or need to clear system BIOS setting.
-
Power off system and disconnect both
power connectors from the
motherboard
Put jumper cap back to Pin_1 and Pin_2
-
(default setting)
Use jumper cap to close Pin_2 and Pin_3
-
Pin_1
for several seconds to Clear CMOS
Reconnect power and power on system
Pin
+
-
State
Color
On
Blue
Off
http://www.tyan.com
http://www.tyan.com
Signal
P3V3_AUX
SYS_ID_SW_N
System identified
Off
System not identified
21
for lastest
Description
Advertisement
Table of Contents
