Fog Lamps; Taillamps, Turn Signal; Stoplamps, And Back-Up; Lamps - Buick Regal Owner's Manual

Front Turn Signal/Parking/
Sidemarker Lamps (Base and
Uplevel)
To replace the front turn signal,
parking lamp, or sidemarker lamp:
1. For the driver side bulb, remove
the windshield washer bottle
filler neck by firmly pulling it
straight up and out of the bottle.
2. Remove the bulb socket from
the headlamp assembly by
turning it counterclockwise.
3. Remove the bulb from the
socket.
4. Replace the bulb in the bulb
socket.
5. Install the bulb socket in the
headlamp assembly by turning it
clockwise.
6. For the driver side, reinstall the
windshield washer bottle filler
neck by firmly pushing it straight
into the bottle. Ensure that the
filler neck clip engages into the
underhood electrical center
retainer.

Fog Lamps

To replace the fog lamp bulb:
1. Locate the bulb assembly under
the front fascia.
2. Disconnect the electrical
connector from the bulb
assembly.
3. Remove the bulb by turning it
counterclockwise and pulling it
straight out of the assembly.
4. Install the new bulb by turning it
clockwise into the assembly.
5. Reconnect the electrical
connector to the bulb assembly.
Vehicle Care

Taillamps, Turn Signal,

Stoplamps, and Back-Up

Lamps

A. Taillamp/Sidemarker Lamp
B. Taillamp
C. Stop/Turn Signal Lamp
D. Back-up Lamp
To replace any one of these bulbs:
1. Open the trunk. See Trunk
Release on page 1 6.
2. Remove the taillamp assembly
access panel.
10-35