Buick Regal Owner's Manual page 265

*
(Cancel): Press to disengage
cruise control without erasing the
set speed from memory.
RES/+ (Resume/Accelerate):
Move the thumbwheel up to make
the vehicle resume to a previously
set speed or to accelerate.
SET/ (Set/Coast): Move the
thumbwheel down to set the speed
and activate cruise control or make
the vehicle decelerate.
Setting Cruise Control
If the cruise button is on when not in
use, it could get bumped and go into
cruise when not desired. Keep the
cruise control switch off when cruise
is not being used.
1
1. Press to turn the cruise
control system on. The indicator
light in the instrument panel
cluster comes on.
2. Get to the speed desired.
3. Move the thumbwheel down
toward SET/ and release it.
The desired set speed briefly
appears in the instrument panel
cluster.
4. Take your foot off the accelerator
pedal.
Resuming a Set Speed
If the cruise control is set at a
desired speed and then the brakes
*
are applied or the button is
pressed, the cruise control is
disengaged without erasing the set
speed from memory.
Once the vehicle reaches about
40 km/h (25 mph) or more, move the
thumbwheel up toward RES/+
briefly. The vehicle returns to the
previous set speed and stays there.
Driving and Operating
Increasing Speed While Using
Cruise Control
If the cruise control system is
already activated:
Move the thumbwheel up toward
.
RES/+ and hold it until the
vehicle accelerates to the
desired speed, then release it.
To increase the speed in small
.
amounts, move the thumbwheel
up toward RES/+ briefly and
then release it. Each time this is
done, the vehicle goes about
1.6 km/h (1 mph) faster.
Reducing Speed While Using
Cruise Control
If the cruise control system is
already activated:
Move the thumbwheel toward
.
SET/ and hold until the desired
lower speed is reached, then
release it.
To slow down in small amounts,
.
move the thumbwheel toward
SET/ briefly and then release it.
9-43