Buick Regal Owner's Manual page 209

Digit Dial: This command allows a
phone number to be dialed by
entering the digits one at a time.
Re dial: This command is used to
dial the last number used on the cell
phone.
Using the "Dial" or "Call"
Command
b g
1. Press / . The system
responds "Ready," followed by
a tone.
2. Say "Dial" or "Call."
3. Say the entire number without
pausing or say the name tag.
Once connected, the person called
will be heard through the audio
speakers.
Using the "Digit Dial" Command
The digit dial command allows a
phone number to be dialed by
entering the digits one at a time.
After each digit is entered, the
system repeats back the digit it
heard followed by a tone.
If an unwanted number is
recognized by the system, say
"Clear" at any time to clear the last
number.
To hear all of the numbers
recognized by the system, say
"Verify" at any time.
b g
1. Press / . The system
responds "Ready," followed by
a tone.
2. Say "Digit Dial."
3. Say each digit, one at a time,
that you want to dial. After each
digit is entered, the system
repeats back the digit it heard
followed by a tone. After the last
digit has been entered,
say "Dial."
Once connected, the person called
will be heard through the audio
speakers.
Using the "Re dial" Command
b g
1. Press / . The system
responds "Ready," followed by
a tone.
Infotainment System
2. After the tone, say "Re dial." The
system dials the last number
called from the connected cell
phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
b g
Press / to answer the call.
.
$ i
Press / to ignore a call.
.
Call Waiting
Call waiting must be supported on
the cell phone and enabled by the
wireless service carrier.
b g
Press / to answer an
.
incoming call when another call
is active. The original call is
placed on hold.
b g
Press / again to return to
.
the original call.
7-45