Charging The Projector; Set Up - Brookstone HDMI Pocket Projector User Manual

chaRGInG The PRojecToR

1 . The Projector is charged using the included AC Adapter .
2 . The LED Indicator Light will illuminate Red to indicate the Projector
is currently charging and then revert to Green when the Projector is
fully charged .
Important: Fully charge the Projector internal battery before first use
(approximately 3 to 5 hours). the approximate run-time is 2 hours.
3 . A low battery icon will show on the screen when the Projector battery
is low . Use the included AC Adapter to charge your Projector . If the
battery is too low, the projector will automatically shut off .

seT UP

1 . Connect one end of the AC adapter to the Projector 12V port and plug
the other end into an electrical outlet .
2 . Connect the HDMI cable (included) to the HDMI port and the other
end to your device .
Note: You may need an adapter to connect your device to the HdMI cable.
Important! apple
for HdMI use. For all other devices, check the manufacturer's instructions.
additional adapter specific to your device may be required (e.g. Micro/Mini HdMI).
3 . Connect a speaker to the 3 . 5 mm audio out jack, if desired .
11
devices require an apple digital aV adapter (sold separately)
®