Bose ControlSpace CC-16 Safety Instructions & Install Manual page 13

Mounting the CC-16 zone controller
Warning: The CC-16 must be installed in a National Electric Code (NEC) approved,
enclosed electrical wall box.
After setting the DIP switches and connecting the wires, mount the CC-16 zone controller in the
electrical box. Two sets of screws are provided. Use the screws that are appropriate for your
wall-box – the #6 for North American boxes, and the M4 for Japanese, European and Australian
boxes.
CAUTION: Do not overtighten the screws. Overtightening may cause the frame to break.
Mounting the CC-16 Zone Controller in a North American 2-gang wall box
After screwing the frame into the wall box, remove the protective clear film and snap on the
cover. The cover can be removed later using a small flathead screwdriver in the slots on the
sides.
Mounting
13