Billion BIPAC 7402G User Manual page 72

Configuring Packet Filter:
1. Click Port Filters. You will then be presented with the predefined port filter rules screen (in this
case for the low security level), shown below:
Note: You may click
how you add a filter on your own.
2. Click Delete to delete the existing HTTP rule.
3. Click Add TCP/UDP Filter.
Click Add TCP/UDP Filter
4. Input the Rule Name, Time Schedule, Source/Destination IP, Type, Source/Destination Port,
Inbound and Outbound.
Example:
Application: Cindy_HTTP
Time Schedule: Always On
Source / Destination IP Address(es): 0.0.0.0
use the port-filter)
Type: TCP (Please refer to Table1: Predefined Port Filter)
Source Port: 0-65535
Redirect Port: 80-80
Inbound / Outbound: Allow
Chapter 4: Configuration
the predefined rule instead of
Edit
(I allow all ports to connect with the application))
(This is Port defined for HTTP)
Billion BIPAC 7402G 802.11g ADSL VPN Firewall Router
it. This is an example to show to
Delete
(I do not wish to active the address-filter, instead I
Click Delete
68