Preparing For Operation; Connecting The Probe; Connecting The Ac Power Cord - Bacharach H25-IR Operation & Maintenance Manual

H25-IR

2 Preparing for Operation

2.1 Connecting the Probe

Plug the probe connector into the front panel PROBE receptacle
by aligning the red dots on both the connector and receptacle. Screw the
flexible probe tube onto the probe assembly.

2.2 Connecting the AC Power Cord

Dependent on the instrument model the H25-IR may use an AC power cord or a
battery pack. Reference your model number to obtain this information.
Disregard any information that does not apply to your model.
The H25-IR is supplied with a 6 foot grounded AC power cord. Make sure that
an AC power receptacle (socket) compatible with this plug is available nearby.
The instrument uses a universal AC power supply that accepts inputs of 100 to
240 VAC, 50/60 Hz. Power consumption is approximately 15 Watts.
Before connecting the AC power cord, first make sure the instrument's power switch is OFF. Next, connect the
power cord to the instrument's rear panel AC power receptacle, and then plug the power cord into a nearby AC
power receptacle.
Instruction 3015-5286
Preparing for Operation
11