Threading The Machine - Baby Lock A-Line Natalie BL18A Getting To Know Manual

Threading the Machine

Raise take-up lever to its highest position by turning the handwheel toward you. Raise presser foot.
Place spool of thread on spool pin as shown, with thread coming from the back of the spool.
1. Following the numbers, thread the machine. Draw thread into thread guide using both hands.
1
3
5
6
2. While holding thread near spool, draw thread down into the tension area
and then around the check spring holder.
3. Firmly draw thread up and through the take-up lever from right to left.
4. Then draw thread down and slip it into the lower thread guide.
5. Draw thread down and slip it into needle bar thread guide on either
right or left side of needle bar.
6. Thread needle eye from front to back.
Note: You may want to cut the end of thread with sharp scissors for easier needle threading.
2
4
4
1
2
3
4
5
6