Pulling Up The Bobbin Thread - Baby Lock Tempo BLTP Instruction And Reference Manual

Pulling up the bobbin thread

When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
1 Insert the bobbin into the bobbin case.
1
• Refer to steps through
bobbin" (page 20).
2 Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
While lightly holding the upper thread with
3
your left hand with the needle in the up-
position, press
button) twice to lower and raise the needle.
1 "Needle Position" button
The bobbin thread is looped around the
upper thread and can be pulled up.
4 Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
5
of "Installing the
("Needle Position"
1
5 Pull out about 10-15 cm (4-5 inches) of the
bobbin thread under the presser foot toward
the rear of the machine.
6 Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
1
2
Upper Threading 29
1