Pulling Up The Bobbin Thread - Baby Lock Spirit BLPY Instruction And Reference Manual

Hide thumbs Also See for Spirit BLPY:

Table of Contents

Press the "Automatic Threading" button to

have the machine automatically thread the

needle.

→ The thread passes through the eye of the needle.

Memo

• When the "Automatic Threading" button is

pressed, the presser foot will be

automatically lowered. After threading is

finished, the presser foot moves back to the

position before the "Automatic Threading"

button was pressed.

Carefully pull the end of the thread that was

passed through the eye of the needle.

If a loop was formed in the thread passed through

the eye of the needle, carefully pull on the loop of

thread through to the back of the needle.

Note

• Pulling the loop of thread gently will avoid

needle breakage.

Pull out about 10-15 cm (approx. 4-6

inches) of the thread, and then pass it under

the presser foot toward the rear of the

machine.

→ Raise the presser foot lever if the presser foot is

lowered.

a About 10-15 cm (approx. 4-6 inches)

Memo

• If the needle could not be threaded or the

thread was not passed through the needle

bar thread guides, perform the procedure

again starting from step

Then, pass the thread through the eye of

the needle after step

Note

• Some needles cannot be threaded with the

needle threader. In this case, instead of

using the needle threader after passing the

thread through the needle bar thread guide

(marked "6"), manually pass the thread

through the eye of the needle from the front

to the back.