Battery Replacement; Programming Of The Lcd Remote Transceiver - Autopage MA-200 Operation Manual

2-way remote control motorcycle alarm
Hide thumbs Also See for MA-200:
Table of Contents

Advertisement

2-WAY LCD REMOTE TRANSCEIVER
Note: If the system is interfered by stronger radio frequency around, sources of high voltage electric power
or such Obstacles like tall buildings and so on, the transmission range may get shorter as the system
uses low out put powered frequency.
A. BATTERY REPLACEMENT:
A 1.5V type AAA Alkaline battery powers the Remote Transceiver. When the power of the battery weakens
a
icon shall be displayed on the LCD screen. When the old battery is replaced to new one, there will
be beep sounds indicate the power is up and the clock on the LCD screen returns to AM12:00 after
displaying all the icons. Correct the time by pressing
Note: Press the
button two times when the battery compartment is empty, then insert the new battery.
B. THE REMORE LCD ICONS WITH FUNCTION:
Armed Mode
Your motorcycle is in the armed
mode
Remote Transmission
You are transmitting the signal to
control unit
Trigger on the Tilt Switch
(Zone 2) optional
Trigger on the Shock Sensor
(Zone 4)
Trigger on the Ignition Switch
(Zone 5).
Time Monitor
Count Down Timer
Reminder when time is up for
parking
Vibration Mode
Remote Control vibrates when the
system is triggered
Driver paging / Lost and Found
Someone is paging you in front of
your motorcycle
C. PROGRAMMING OF THE LCD REMOTE TRANSCEIVER:
Transceiver Button
Description
(1 second)
LCD screen lamp turns on for
5 seconds.
(3 seconds)
Timer Programming Mode.
MA-200 OP REV.A
:
for 3 seconds before using (See Timer Setting).
Disarm
The system is Disarmed.
In – Range Indicator
Your are within the remote controls
range.
Trigger on the Close Loop
(Zone 3).
Activate on the Warn away Trigger
Alert Alarm
You have set morning call alarm
Power Save Mode
Save the battery power
Button Lock
Disable the transmission function
temporarily
Low Battery
You have to replace the battery of
remote control.
Operation
Press and hold the
1 second, 1 melody sound will
confirm entry.
Press and hold the
3 seconds, 2-melody sounds will
confirm entry.
8
Oct/23/2006
button for
button for

Advertisement

Table of Contents
loading

Table of Contents