Autopage RF-700 Operation Instructions Manual page 15

The RF-700 includes two, 4 button mini remote control transmitters with LCD (Liquid Crystal Display)
readouts which must be programmed to the alarm before any alarm function is possible. This action is
normally done at the time of installation, however there may be occurrences when you wish to enter the
programming mode.
NOTE: Each time the programming mode is entered, all previously programmed transmitter codes will
be automatically deleted and must be reprogrammed. This is an important security feature. If any
transmitter is lost or stolen, enter the programming mode and reprogram existing transmitters.
Transmitters can only be programmed by entering the programming mode.
NOTE: Any transmitters programmed to the RF-700 will remain in memory during times when certain
vehicle service procedures make it necessary to disconnect the battery.
To program the RF-700 transmitters, follow the directions as written below, in their exact order!
To enter the programming mode switch the ignition ON, then push the momentary valet/override switch
five times. The siren or horn will chirp three times. Push the ARM button on one of the transmitters.
The siren or horn will chirp one time to confirm the RF-700 has accepted the code. Push the ARM
button on the remaining transmitter. The siren or horn will chirp one time to confirm the RF-700 has
accepted the code. To close the programming mode, switch off the ignition.
NOTE: The RF-700 will accept up to four transmitters. Consult your AutoPage dealer for the
purchase of additional transmitters.
1. TWO AND THREE VEHICLE OPERATION (M)
Press the MODE button on the transmitter to select CAR #2 or CAR #3. Consult the MODE
COMMANDS flow chart for details.
VEHICLE #2 (*)
Enter the programming mode on vehicle #2 and push the ARM button on the transmitter. The vehicle
horn or siren will respond with a confirming chirp.
VEHICLE #3 (*)
Enter the programming mode on vehicle #3 and push the ARM button on the transmitter.
The vehicle horn or siren will respond with a confirming chirp.
(*) All vehicles must be equipped with RF-700 alarm systems.
NOTE: If the transmitter for the primary vehicle has been programmed to operate one or two other
vehicles, it will not be possible to set PROGRAM COMMANDS on CAR #2 or CAR #3 with the
15