Assembly Instructions - Audio Note AN/E Series Owner's Information

Assembly Instructions

Assembly of the stands is quite straightforward. Please bear in mind, however, that these stands are quite heavy
(especially if you decide to fill them) so care should be taken accordingly during assembly and final positioning etc.
Copyright © 2006 Audio Note (UK) Limited
Website www.audionote.co.uk
E-Mail info@audionote.co.uk
Telephone +44 (0) 1273 731498
Construction begins with the base plate.
The base plate is the plate that does not have any
countersunk holes in it (distinguishing it from the top plate).
The picture opposite shows the base plate and highlights
the locations of the holes that will allow you to fix the four
vertical columns.
These holes will accept the button-head screws, which will
be inserted from below.
Each column should now be fixed in place onto the base
plate using the button-head screws (2 per column).
Make sure that the screws are well tightened and secure.
If you intend to fill your speaker stands then this would be a
good time to do so - although filling is optional.
For filling, we recommend either just sand or a lead-
shot/sand combination.
Filling is done by pouring your chosen filler through the
central hole in each of the columns.
The sand that you use should be a dry, fine one. It is also
advisable that you temporarily place some adhesive tape
over the fixing holes to stop any sand getting into the screw
threads so as not to cause problems later when you come
to screw the top plates in place. Use of a funnel is also
recommended.
Page 5