ATN Night Spirit User Manual page 7

scope ADApTer mounT wiTh 1x lens
(opTionAl)
the night Spirit may be mounted to a variety of
daytime scopes/telescopes utilizing the Scope
Adapter Mount.
1. replace the standard 3X objective lens
of night Spirit to the 1X lens for using with
headgear.
2. Loosen the adapter fixing screws [1].
3. put the insert into the adapter (Atn sup-
plies inserts of different sizes for their cou-
pling with 38 mm to 43 mm eyepieces).
4. now attach the monocular to the bracket [2] and tighten fixation knob [4].
5. push a daytime riflescope or telescope eyepiece into the adapter attached to the monocu-
lar, making sure a small space is left between the scope eyepiece and the monocular front
lens.
6. tighten the adapter screw [1] securely.
WARNING: Do not use with illuminated reticle daytime scopes. May cause damage to night
spirit. This damage is not covered by warranty.
450 mw inFrA-reD illuminATor
1. Attach the Ir450 adapter to the night Spirit. Screw the screw of adapter into the mounting
thread of device.
2. place the Ir450 onto the rail of adapter. Screw the fixing nut of Ir50 mount tightly.
Ir BrIGhtneSS ADJUStMent
Ir WInDAGe
ADApter
ADJUStMent
FIXInG nUt
Infra-red (Ir) Illuminators are common for night vision tech-
nology. the Ir light greatly enhances the performance of your
device, while remaining almost totally invisible to the naked
eye. Staying in the dark, switch on your night vision device.
If the visibility is low, you may use Atn Ir450 to improve the
situation. Still, you should remember that the Ir illuminator
is just a source of infrared light so the greater is the chosen
range of observation, the lesser its brightness becomes.
Ir450 Infrared Illuminator can be mounted with pS-22 onto
the picatinny rail, platform ring, BAM system or on to the
weapon bases.
Ir450 Installation:
Ir eLevAtIOn
ADJUStMent
Ir FOCUSInG
BAtterY hOUSInG
WrenCh
ALLen KeY
4
3
pOWer LeD InDICAtOr
nUt
BAtterY
hOUSInG CAp
2
1
(opTionAl)
WrenCh
tO LOOSen nUt
COntrOL pAneL
tO tIGhten
nUt
nUt
6