ATN Night Spirit User Manual page 6

Hide thumbs Also See for Night Spirit:
Table of Contents

Advertisement

6. Loosen the knob [7] and move the
unit along the rail [3] for precise eye
relief adjustment. Fixate the knob
[7] in the needed position.
If you need increase the eye relief of
your goggles additionally, you can
displace the bracket on the top of
transfer piece.
7. Unscrew the screw [14] and detach
the end-cap [13] from the bracket of
transfer piece.
8. Unscrew the 2 screws [12] and
detach the bracket from the transfer
piece.
9. turn the bracket 180 degrees.
10. Screw the 2 screws [12] back into
place.
11.put the end-cap [13] on to the
place. Screw the screw [14] in to the
place.
Flip-up mechAnism
the night Spirit headset has a flip-up mechanism. push the button [1] on the side of mount and
lift the unit up until the unit fixates in the top position. push same button to lower night Spirit to
viewing position.
WARNING: It is critical that the goggles be turned off manually before placing them in the flipped
up position in order to avoid detection by the enemy.
picATinny mounT ADApTer wiTh
1x lens
the night Spirit may be mounted behind a variety of
daytime night vision compatible holo/reflex sights (i.e.
eOtech or Aimpoint) utilizing the picatinny mount
adapter with 1x lens.
WARNING: Do not use non-night vision compatible
sights. May cause damage to night spirit. This damage
is not covered by warranty.
to mount night Spirit perform the following:
1. replace the standard 3X objective lens of night Spirit to the 1X lens for using with head-
gear.
2. Mount the cleat to the body of night Spirit.
3. Loosen the clamping knob on the weapon mount. position the monocular mount onto the
weapon's mounting rail, behind daytime sight adjust the fore/aft position of the monocular
as necessary by loosening the clamping knob and repositioning the weapon mount on the
rail. tighten by turning the clamping knob.
4. Align the monocular and the weapon mount. Slide the monocular rearwards until the align-
ment boss aligns with the alignment groove on the weapon mount. push until the monocular
locks into the weapon mount.
5
(opTionAl)
8
9
10
14
13
12
11

Advertisement

Table of Contents
loading

Table of Contents