Ir450 Illuminator - ATN PS-22 Operator's Manual

6. Install the top halves of the inserts (6) and the rings (7) and
tighten each ring's four screws (8) to finger tight.
7. Install the top of the mount (9) and tighten four screws (10) to
finger tight.
8. Slightly loosen the two fixing screws (11) on the top rail (12).
9. place the top rail onto the picatinny rail on the top of the
mount.
10. tighten the fixing screws of the top rail.
11. place the night vision Front Sight (13) onto the top rail at front
of the scope. the light suppressor of the front sight should cov-
er the riflescope objective lens.
12. place the infra-red illuminator (14) atop of the top rail.
You can quickly change your system back from night vision to day.
Simply unscrew two fixing screws of the top rail and take off the
top rail together with the front sight and Ir illuminator.
NOTE
The fixing screws may need to be tightened after continuous
shooting.

2.3.7. IR450 ILLUMINATOR

Infra-red (Ir) Illuminators are common for night vision technology.
the Ir light greatly enhances the performance of your device,
while remaining almost totally invisible to the naked eye. Staying
in the dark, switch on your night vision device. If the visibility is
low, you may use atn Ir450 to improve the situation. Still, you
should remember that the Ir illuminator is just a source of infrared
light so the greater is the chosen range of observation, the lesser
its brightness becomes.
Ir450 Infrared Illuminator can be mounted with pS-22 onto the
picatinny rail, platform ring, Bam system or on to the weapon
bases.
Ir450 Installation:
1. loosen the fixing nut of Ir450.
2. Install the Ir450 onto the picatinny rail (Figure 2-5), Bam Sys-
tem (Figure 2-13) or platform ring (Figure 2-12).
2-16