Installation And Use Of Accessories; 7/8" Weaver Mount; Remote Control - ATN PS-22 Operator's Manual

Night vision front sight

Hide thumbs Also See for PS-22:

Table of Contents

2.3. INSTALLATION AND USE OF

ACCESSORIES

Optional 7/8" Weaver Mount is used for installation the PS-22 on

7/8" Weaver rail instead of the issued mount.

NOTE

If using weaver rails, please consult your gunsmith for modifica-

tion to rail.

1. loosen and remove two screws m4x8 which secure the Qr

mount to the sight body. remove the Qrm.

CAUTION

Use of screws longer than 8 mm will damage power switch.

2. put the Weaver mount on the sight body. the mount nuts should

be placed the same side as switch knob. apply a small amount

of thread locker on threads, install two screws m4x8 and tighten

it.

3. loose the mount nuts. Install the sight onto the rail as close to

the riflescope as possible. the light suppressor should cover the

riflescope objective lens.

4. tighten the mount nuts using screwdriver.

FIGURE 2-9. ASSEMBLING PS-22 wITH 7/8" wEAVER MOUNT

remote control is designed to operate the pS-22 in short-time ac-

tivation mode.

2-12

m4X8 SCreWS

Table of Contents