Set Up Mp Wifi Client Configuration; Connect A Pc To The Mp Ethernet Port With Dhcp; Reference - ATCOM MP01 Setup Manual

The MP will restart. Allow several minutes for the MP to become fully operational
in the new mode.
3.2

Set up MP Wifi Client configuration

Browse to the MP Fallback address 172.31.255.254 to get to the OpenWRT LuCI
login page. Log in as root and go to menu item Network/Wifi/WIFI0. Set the
Channel, ESSID, Encryption type (eg WPA-PSK), and passphrase key, to match
the required AP settings. Scroll down and click 'Save&Apply'. The screen will
refresh and the MP should associate with the required AP after a short time.
3.3

Connect a PC to the MP Ethernet port with DHCP

Connect a PC, with its ethernet port configured for DHCP, to the MP ethernet
port. The PC should acquire an IP address lease in the range 10.10.10.100 - 200
Check that you can connect to the MP Ethernet address 10.10.10.1 Check that
you have internet access on the PC by browsing to an internet site.

4. Reference

http://wiki.villagetelco.org/
http://www.atcom.cn/
6