This chapter presents step-by-step installation instructions
for this eight-port Fiber-optic Fast Ethernet Switch.
Selecting a Site for the Switch
As with any electronic device, you should place the Switch
where it will not be subjected to extreme temperatures,
humidity, or electromagnetic interference. Specifically, the
site you select should meet the following requirements:
♦
The room temperature should be between 0 and 50
degrees Celsius.
♦
The relative humidity should be less than 90 percent,
non-condensing.
♦
Surrounding electrical devices should not exceed
the electromagnetic field (RFC) standards for IEC
801-3, Level 2 (3V/M) field strength.
♦
Make sure that the switch receives adequate
ventilation. Do not block the ventilation holes on the
side of the switch or the fan exhaust port on the rear
of the switch.
♦
The power outlet should be within 1.8meter (6 feet)
of the switch.
Detailed specifications may be found on page 17 and 18.
FNSW-8086 / 8088F User's Manual
Chapter 2. Installation
13