Table of Contents
Advertisement
FDX/ COL: The lower LED is illuminated when the port
is operating in full-duplex mode. When this
LED is off, the port is operating in
half-duplex mode.
The LED flashes when the switch detects
packet collisions on the port.
Pow er
This LED comes on when the switch is connected to a
power supply and turned on.
Auto MDI-X
If connecting to an uplink port of a hub or another
switch, any of the switch ' s RJ-45 ports can be used.
There is no auto MDI -X for fiber 100BASE-FX ports; thus
the auto MDI -X status does not apply to 100BASE-FX
ports.
DIP Sw itch
Full-Duplex: Toggle on to enable Full-Duplex mode for
100BASE-FX ports (Default setting).
Half-Duplex: Toggle down to enable Half-Duplex mode
for 100BASE-FX ports.
FNSW-8086 / 8088F User's Manual
11
Advertisement
Table of Contents
