Chapter 5 Troubleshooting; Appendix A Troubleshooting - Planet FNSW-2402S User Manual

This chapter contains information to help you solve problems. If the Ethernet Switch is not
functioning properly, make sure the Ethernet Switch was set up according to instructions
in this manual.
The Link LED is not lit
Solution:
Check the cable connection and remove duplex mode of the Ethernet Switch
Some stations cannot talk to other stations located on The other port
Solution:
Please check the VLAN settings, trunk settings, or port enabled / disabled status.
Performance is bad
Solution:
Check the full duplex status of the Ethernet Switch. If the Ethernet Switch is set to
full duplex and the partner is set to half duplex, then the performance will be poor.
Please also check the in/out rate of the port.
100Base-TX port link LED is lit, the collision LED is blinking, but traffic is
irregular
Solution:
Check that the attached device is not set to dedicated full-duplex. Some devices use
a physical or software switch to change duplex modes. Auto-negotiation may not
recognize this type of full-duplex setting.
Chapter 5
TROUBLESHOOTING
33