Planet FNSW-2402S User Manual page 15

VLAN Provide port based VLAN (support overlapping) and IEEE
Configuration 802.1Q VLAN. Please refer to section 3.2.3.3 for detail con-
figuration.
Account Allow user to modify the username and password for FNSW-
Configuration 2402S, enable Retry Forever options, enable MAC address
table auto-aging. Also provides two options of MAC address
table hash algorithm. Please refer to section 3.2.3.4 for detail
configuration.
Main Menu Return to the main menu. Please refer to section 3.2.3.5 for
detail configuration.
Table 3-2 Descriptions of the Switch Configuration Screen Objects
3.2.3.1 Port Configuration
Use the "TAB" key to move the highlight to the Port Configuration and press "Enter" to
access the screen of Port Configuration from the Switch Configuration screen (please see
the figure3-5). The screen of Port Configuration in Figure 3-6 appears. Table 3-3 describes
the Port Configuration objects of FNSW-2402S. This menu allows you to view or change
the port configuration of FNSW-2402S. The user can set rate control on each port and
determine each port's disabled/enabled, auto-negotiation, NWAY-FORCE or FORCE mode,
speed, duplex mode, flow control and rate control. Use the "TAB" key to choose the
<Edit> then press "Enter". Then start to modify these settings. Use the "TAB" key to move
the highlight to the object and press the "Space Bar" key to toggle back and forth between
the options. After setup completed, press "Ctrl-A" key to return to Actions menu and use
the "TAB" key to choose the <Save> for saving the current configuration.
Figure 3-6 Port Configuration Screen
13