Chapter 3
Installation
The Fast Ethernet Switch do NOT require software configura-tion. Users can immediately
use any of the features of this product simply by attaching the cables and turning on the
power.
To get the best use of these Fast Ethernet Switch models, many things need to be
considered first. See Section 4, OPTIMIZING CONFIGURATION for details.
3.1 Rack-Mount Installation
Most users prefer to attach the power cord to the hub before installation in a network
rack. Do not plug the other end of the cord into a power outlet until after the Switch is
installed.
For mounting the Fast Ethernet Switch in a network rack, first attach the rack-mount
brackets to the side of the hub with screws. (Both brackets and screws are included in the
product package.) Slide the hub into the rack and align the holes in the bracket with the
corresponding holes in the network rack. Attach the bracket to the rack with the enclosed
screws.
3.2 Desktop Installation
To locate the Fast Ethernet Switch models on a desktop, first attach the four rubber feet to
the bottom of the hub, one in each corner. Place the hub on a clean, flat desk or table-top
close to a power outlet. Make sure there is no hindrance behind the fan of the hub
Plug in all network connections and then turn the switch on via plug in the power cord.
7