Table Of Contents; Connecting The Units - Pioneer AVH-P3150DVD Installation Manual

Contents
Connecting the units ............................ 2
Parts supplied .................................................. 4
Connecting the system .................................... 5
Connecting the power cord
When connecting to
separately sold power amp ........................ 8
When connecting
with a rear view camera .............................. 9
When connecting
with a multi-channel processor ............... 10
Connecting and installing
the optical cable connection box ............. 11
Connecting the optical cable .................................11
Installing the optical cable connection box ..........11
When connecting the external
video component and the display ............ 12
When using a display connected to
rear video output ............................................12
Installation ........................................... 13
Installation using the screw holes
on the side of the unit ............................. 13
2
• To avoid the risk of accident and the potential
6
...............................
• In some countries or states the viewing of images
• PIONEER does not recommend that you
• Secure all wiring with cable clamps or
• Do not drill a hole into the engine
• It is extremely dangerous to allow the display
• Make sure that wires will not interfere with
• Do not shorten any leads. If you do, the
<CRD4373-A> <2>

Connecting the units

WARNING
violation of applicable laws, the front DVD or
TV (sold separately) feature should never be
used while the vehicle is being driven. Also, rear
displays should not be in a location where it is a
visible distraction to the driver.
on a display inside a vehicle even by persons
other than the driver may be illegal. Where such
regulations apply, they must be obeyed and this
unit's DVD features should not be used.
CAUTION
install or service your display yourself.
Installing or servicing the product may
expose you to risk of electric shock or other
hazards. Refer all installation and servicing
of your display to authorized Pioneer service
personnel.
electrical tape. Do not allow any bare wiring
to remain exposed.
compartment to connect the yellow lead
of the unit to the vehicle battery. Engine
vibration may eventually cause the insulation
to fail at the point where the wire passes from
the passenger compartment into the engine
compartment. Take extra care in securing the
wire at this point.
lead to become wound around the steering
column or gearshift. Be sure to install the
display in such a way that it will not obstruct
driving.
moving parts of the vehicle, such as the
gearshift, parking brake or seat sliding
mechanism.
protection circuit may fail to work properly.
WARNING
LIGHT GREEN LEAD AT POWER CONNECTOR
IS DESIGNED TO DETECT PARKED STATUS
AND MUST BE CONNECTED TO THE POWER
SUPPLY SIDE OF THE PARKING BRAKE SWITCH.
IMPROPER CONNECTION OR USE OF THIS
LEAD MAY VIOLATE APPLICABLE LAW AND MAY
RESULT IN SERIOUS INJURY OR DAMAGE.