The Video Parameter Setting; Video Converter; Resolution - Pioneer VSX-920 Operating Instructions Manual

06 The System Setup menu

The Video Parameter setting

This receiver can up-convert the video signal
input from the composite/component video
terminals; the output is from the HDMI OUT
terminal. The following shows the various
settings for this function.
1 Press
RECEIVER
then press the SETUP button.
An on-screen display (OSD) appears on your
TV. Use /// and ENTER on the remote
control to navigate through the screens and
select menu items. Press RETURN to confirm
and exit the current menu.
System Setup
2 Select 'Video Parameter' from the
System Setup menu.
System Setup
1.Auto MCACC
2.Manual SP Setup
3.Input Assign
4.Speaker System
5.Video Parameter
3 Select the setting you want to adjust.
If you are doing this for the first time, you may
want to adjust these settings in order:
• Video Converter – Converts video signals
for output from the HDMI OUT terminal for
all video types (see below).
• Resolution – Specifies the output
resolution of the video signal (see below).
• Aspect – Specifies the aspect ratio
(page 51).
4 Make the adjustments necessary for
each setting, pressing RETURN to confirm
after each screen.
50
En
on the remote control,
1.Auto MCACC
2.Manual SP Setup
3.Input Assign
4.Speaker System
5.Video Parameter
Return
5.Video Parameter
a.Video Converter
b.Resolution
c.Aspect
Return Return

Video Converter

This setting specifies valid/invalid for the
function that converts the input video signal
from each composite/component video
terminal. When OFF is selected, Resolution
and Aspect can not be set.
1 Select 'Video Converter' from the Video
parameter menu.
5.Video Parameter
a.Video Converter
b.Resolution
c.Aspect
Return
2 Select the setting for converting each
type of video input.
• ON – The signal is output also to the HDMI
OUT terminal.
• OFF – The signal input from the HDMI
terminal of the selected input function will
be output from the HDMI OUT terminal.
The signal input from the analog
composite video and the component video
will not be output from the HDMI OUT
terminal.
3 When you're finished, press RETURN.
You return to the Video Parameter menu.

Resolution

Specifies the output resolution of the video
signal (when video input signals are output at
the HDMI OUT terminal, select this according
to the resolution of your monitor and the
images you wish to watch).
1 Select 'Resolution' from the Video
parameter menu.
5.Video Parameter
a.Video Converter
b.Resolution
c.Aspect
Return
5a.Video Converter
ON
BD
DVD [ O F F ]
TV/SAT [ O F F ]
DVR/VCR [ OF F ]
Return
5b.Resolution
Resolution AUTO
Return