The Speaker System Setting; The Video Parameter Setting; Video Converter; Resolution - Pioneer VSX-921-K Operating Instructions Manual

06 The System Setup menu
06

The Speaker System setting

Specify either using the surround back speaker (or the
speaker B), or the front height speaker connection with the B-
speaker terminals.
• Default setting: Surr. Back
1
Select 'Speaker System' from the System Setup menu.
System Setup
4.Speaker System
1.Auto MCACC SP System
2.Manual SP Setup
3.Input Assign
4.Speaker System
5.Video Parameter
6.HDMI Setup
7.Auto Power Down
8.FL Demo Mode
Return
Select the speaker system setting using /.
2
• Surr. Back – Sound is output from the surround back
speaker or the speaker B.
• Height – Sound is output from front height speaker.
3
When you're finished, press RETURN.
You return to the System Setup menu.
40
En

The Video Parameter setting

This receiver can up-convert the video signal input from the
composite/component video terminals; the output is from
the HDMI OUT terminal. The following shows the various
settings for this function.

Video Converter

This setting specifies valid/invalid for the function that
converts the input video signal from each composite/
Surr. Back
component video terminal. When OFF is selected, Resolution
and Aspect can not be set.
1
Select 'Video Parameter' from the System Setup menu.
2
Select 'Video Converter' from the Video Parameter
Return
menu.
5.Video Parameter
a.Video Converter
b.Resolution
c.Aspect
3
Select the setting for converting each type of video
input.
• ON – The signal is output also to the HDMI OUT terminal.
• OFF – The signal input from the HDMI terminal of the
selected input function will be output from the HDMI OUT
terminal. The signal input from the analog composite
video and the component video will not be output from
the HDMI OUT terminal.
4
When you're finished, press RETURN.
You return to the Video Parameter menu.
5a.Video Converter
DVR/BDR ON
DVD
[ OF F ]
BD [ OF F ]
VIDEO1 [ O F F ]
Return
Return

Resolution

Specifies the output resolution of the video signal (when
video input signals are output at the HDMI OUT terminal,
select this according to the resolution of your monitor and
the images you wish to watch).
1
Select 'Video Parameter' from the System Setup menu.
2
Select 'Resolution' from the Video Parameter menu.
5b.Resolution
5.Video Parameter
a.Video Converter Resolution
b.Resolution
c.Aspect
Return
3
Select output resolution.
• AUTO – The resolution is selected automatically
according to the capacity of the TV (monitor) connected
by HDMI.
• PURE – The signals are output with the same resolution
as when input.
• 480p/720p/1080i/1080p – The signal is output with the
resolution specified here (480p means the resolution of
480p/576p).
4
When you're finished, press RETURN.
You return to the Video Parameter menu.
Note
• When set to a resolution with which the TV (monitor) is
not compatible, no picture is output. Also, in some cases
no picture will be output due to copyright protection
signals. In this case, change the setting.
• When a display is connected by HDMI, if this is set to
something other than PURE and 480i/576i analog signals
are input, 480p/576p signals are output from the
component output terminals.
AUTO
Return