Table of Contents
Advertisement
Once you have configured the Model 2030 properly, follow these
steps to install the unit:
1.
Plug the Model 2030 directly into the 36-Pin Centronics
interface. Where necessary, a short (6ft maximum) parallel
printer cable may be used.
2.
The RS-232 interface is wired as a DCE (see below)
according to the EIA-561 Standard. Connect the Model 2030
to your Serial RS-232 DTE device using a straight through
modular cable:
3.
The Model 2030 derives power from the RS-232/423 and
IEEE 1284 interfaces. IMPORTANT: For the Model 2030 to
operate as an interface powered device, the IEEE 1284 B
interface must support the optional 5V on pin 18, and IEEE
1284 C must support interface pin 36 (peripheral logic high). If
the IEEE 1284 interface does not meet these requirements,
you must supply power to the Model 2030 using the option
wall mount AC power supply.
4.0 INSTALLATION
RJ-45 (DCE)
1-----------------------------DSR
2-----------------------------CD
3-----------------------------DTR
4-----------------------------SG
5-----------------------------RD
6-----------------------------TD
7-----------------------------CTS
8-----------------------------RTS
6
SIGNAL
®
Advertisement
Table of Contents
