Detailed Switch Settings - Patton electronics 2026 User Manual

Position
SW1
SW2
SW3
SW4
SW5
SW6
SW7
SW8
The Model 2026 and Model 2027 use a miniature configuration
switch package. To configure your unit, use a small screwdriver and
gently push each switch to its proper setting. The ON and OFF
positions are shown in Figure 2. Default settings for the DIP switches
are shown in the table on the following page. Detailed settings follow
the table.

3.2 DETAILED SWITCH SETTINGS

This section provides detailed information about the function of
each DIP switch and lists all possible settings.
The setting for Switch 1 determines whether these interface
converters will control either hardware or software flow control.
Enable/Disable LED Indicator
The setting for Switch 2 determines whether the LED indicator is
enabled or disabled.
DIP SWITCH SUMMARY TABLE
Function
Flow Control
LED Indicator
Data, Parity, Stop Bits
Data, Parity, Stop Bits
Data, Parity, Stop Bits
Data Rate
Data Rate
Data Rate
Flow Control SW1
Hardware
Software
LED
Enabled
Disabled
5
Factory Default
Hardware
Off
On
Off
}
Off
Off
}
Off
Off
Off
Switch 1:
OFF
Hardware/Software
ON
Control
SW2
ON
OFF
Switch 2:
Enabled
8B, NP, 1S
9600 bps