Model 222NRCs are available with RJ-11 or RJ-45 rear interface cards. For workgroup and desktop communications, the Model 222NRC also fits in Patton’s 2, 4 and 8 slot Cluster Boxes. The combination of rack mount, Cluster Box and interface powered units provides a completely integrated “networking”...
Page 4
LEDs and the CD signal exiting the rear interface card in the rack. the RS-232 and twisted pair lines. Since the Model 222NRC contains two converters, each unit can be configured separately. Both “Carrier Detect” straps can be set to “Normal” or “Always on”.
Position 1&2 = Line A Shield Connected to Frame Ground This section describes the functions of the Model 222NR16P rack Position 2&3 = No Shield chassis, tells how to install front and rear Model 222NRC cards into the chassis and provides diagrams for wiring up the interface connections correctly.
4.2 INSTALLING THE MODEL 222NRC INTO THE CHASSIS The Model 222NRC operates full duplex over two twisted pair. The Model 222NRC is comprised of a front Functions card and a In all applications, the twisted pair wire must be 26 AWG or thicker, rear Interface card.
222NRC when its card-edge connector touches the chassis' mid-plane socket, or when the chassis' power is turned on. Note: The 222NRC is a "hot swappable" card—it will not be damaged by plugging it in or removing it while the rack is powered up.
APPENDIX A APPENDIX B CABLE RECOMMENDATIONS SPECIFICATIONS The Patton Model 222NRC operates at frequencies of 20kHz or less Transmission Format: Asynchronous and has been performance tested by Patton technicians using twisted- pair cable with the following characteristics: Data Rate: 0 to 19.2 Kbps...
APPENDIX C APPENDIX D FACTORY REPLACEMENT PARTS INTERFACE SETTINGS & ORIENTATION The Patton Model 222NRC rack system features interchangeable PATTON MODULAR INTERFACE - 10 Wire RJ-45 rear half cards, power cords/fuses for international various operating Contact Number Circuit Description environments and other user-replaceable parts. Model numbers and...