Table of Contents
Advertisement
Controls and their functions
Rear MIC1 connector [MIC1]
An audio component or microphone is connected to this
connector.
The gain setting can be selected on the camera menu.
Rear MIC2 connector [MIC2]
An audio component or microphone is connected to this
connector.
The gain setting can be selected on the camera menu.
DC output connector [DC OUT]
The R or G tally signal is output from this connector
(open collector). A DC 12 V power supply (up to 1.0 A)
can also be supplied.
If the current exceeds the rating, the power is turned off
forcibly.
Earphone jack [EARPHONE]
When an earphone (optional accessory) is connected to
this jack, the INCOM1 receiving signals can be heard.
Data trunk connector [TRUNK]
The trunk data [RS-422 2 or RS-232C 2] of the CCU
is input to and output from this connector.
The camera menu is used to select the setting.
MIC1 power selector switch
This is used to select what kind of power is to be supplied
to MIC1. (The switch is set to phantom 48 V, AB 12 V or
OFF.)
MIC2 power selector switch
This is used to select what kind of power is to be supplied
to MIC2. (The switch is set to phantom 48 V, AB 12 V or
OFF.)
Grip PTT switch [PTT]
This selector switch is used to set the INCOM1 MIC to
ON or OFF.
The camera menu is used to select the setting.
Grip RET switch [RET]
This is used as return image selector switch.
The camera menu is used to select the setting.
Optical filter selector switch [FILTER LOCAL]
When this switch is pressed and the filter local LED
lights, the optical filter can be adjusted manually.
When it is pressed again, the optical filter can be
controlled by the ROP.
Filter local LED [LOCAL]
While this LED is lighted, the optical filter can be adjusted
manually.
Monitor output selector switch [MONI SEL]
This is used to select the viewfinder image and the HD
SDI2 image (Y, NAM, R, G, B) in the VF OUT status.
ND filter selector knob
This is used to adjust the optical filter manually when
LOCAL has been selected as the filter setting.
1: CAP, 2: Through, 3: 1/4, 4: 1/16, 5: 1/64
Do not turn this knob while the filter local LED is off.
CC filter selector knob
This is used to adjust the optical filter manually when
LOCAL has been selected as the filter setting.
A: 3200K, B: 4300K, C: 6300K, D: Cross, E: DF0
Do not turn this knob while the filter local LED is off.
Gain selector switch [GAIN]
This is used to select the gain for the camera images.
(LOW, MID, HIGH)
It is not effective when the CCU is connected to the
camera.
The gain setting can be selected on the camera menu.
Camera output selector switch [OUTPUT]
This is used to select the video output (CAM, BAR or
TEST).
It is not effective when the CCU is connected to the
camera.
White balance memory selector switch [W.BAL]
This is used to select the white balance memory.
Data can be recorded in A or B.
The factory settings are established when the switch is
set to PRST.
It is not effective when the CCU is connected to the
camera.
Assignable switch [USER 1, 2, 3]
The ON/OFF function settings established ahead of time
can be allocated to these switches using the camera
menu.
10
Advertisement
Table of Contents
