Network - TP-Link TL-WA801ND User Manual

the AP into the field after "Access Point PIN". Then click Next.
Note:
The default PIN code of the AP can be found in its label or the WPS configuration screen as Figure
4-5 .
You will see the following screen when the new device has successfully connected to the network.
Note:
1. The WPS LED on the AP will light green for five minutes if the device has been successfully
added to the network.
2. The WPS function cannot be configured if the Wireless function of the AP is disabled. Please
make sure the Wireless function is enabled before configuring the WPS.

4.5 Network

The Network option allows you to customize your local network manually by changing the default
settings of the AP.
Selecting Network will enable you to configure the IP parameters of Network on this page.
TL-WA801ND
The WPS Configuration Screen of Wireless Adapter
300Mbps Wireless N Access Point User Guide
22