When The Engine Is Cold - Echo CS-370 Instruction Manual

Choke control knob
Choke
Starter handle
Choke control knob
Open choke
Chain brake
Ignition switch
Start / Run
Purge pump

WHEN THE ENGINE IS COLD

CAUTION
Make sure the bar and chain are free from any
obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock chain
brake before starting.
• Fill the fuel tank with fuel mixture. Do not over fill.
• Fill the chain oil tank with lubricant. Do not over fill.
• Move ignition switch to "RUN" position.
• Push purge pump 3 to 4 times or until fuel is visible in
purge pump.
• Pull choke control knob all the way out. (Choke posi-
tion)
NOTE
Do not pull starter rope out to the maximum possible
position.
Do not allow recoil handle to snap back against the
casing.
• Securely hold the chain saw as shown and pull
starter handle several times until first firing sound.
• Push choke control knob all the way in.
• Pull starter handle to start the engine.
NOTE
If engine does not start after 5 pulls, repeat instructions.
NOTE
Do not increase engine speed while chain brake is
locked. Severe brake damage will result.
17
CS-370