DLS MB5i Owner's Manual

MB5
FOR OUTDOOR & INDOOR USE
D L S B O X S P E A K E R S
Thank you for purchasing DLS all-weather speaker.
This manual will show you how to do a correct instal-
lation. Please read the entire manual before you begin
the install.

Features and benefits:

- Excellent audio performance, transparent
and clear sound.
- Easy installation
- 2-way bass reflex system
- Adjustable tweeter level in two steps
Installation
The speakers are rather heavy which must be taken in conside-
ration at the install. Fasten the speaker bracket to a solid and
stable surface with two stainless steel screws.
The speaker box can be installed hanging from the ceiling, on a
wall or standing up using the tilt able bracket.
NOTE! On a boat, avoid an installation close to any magnetic
compass; the speaker magnets can influence the compass
needle.
The MB5i / MB6i is weather resistant, designed for use outdoors
and indoors. Bracket and front grille is aluminum.
The MB5i /MB6i is also well suited for use in garden terraces
and public use like shops, restaurants etc.
Break-in period
Allow the speakers to play at normal volume for at least 15-20
hours. After this time the performance is correct.
Technical Assistance
For technical assistance ask the shop where the product was sold
or the distributor in your country. You can also send an e-mail to
info@dls.se
Information can also be found on our web-site www.dls.se
We follow a policy of continuous advancement in development.
For this reason all or part of specifications & designs may be
changed without prior notice.
Warranty service
This speaker is covered by warranty, depending on the condi-
tions in the country where it is sold. If the speaker is returned for
service, please include the original dated receipt (or a copy) with
the product.
More facts:
Speaker type
Available colors
Impedance
Amplifier impedance
Size of bass driver
Tweeter
Nom. power
Maximum power
Frequency range +-3dB
Tweeter level
Sensitivity
Temp. range
Outer size
Weight per speaker
DLS Svenska AB 2012-11-16
/ MB6
i
2-way bass reflex in PVC
White or black
8 ohm
4-8 ohm
MB5i: 5,25" (13 cm)
MB6i: 6,5" (16,5 cm)
MB5i: 20 mm /0,8" soft dome
MB6i: 25 mm /1" soft dome
MB5i: 80 Watts RMS
MB6i: 110 W RMS
MB5i: 160 Watts
MB6i: 220 W RMS
MB5i: 70 Hz-20 kHz
MB6i: 55 Hz - 20 kHz
Adjustable in 2 levels, HI / LOW
90 dB / W / m
-20 - +85 degrees C.
MB5i: W: 240 mm, H: 185 mm, D: 165 mm
MB6i: W: 300 mm, H: 215 mm, D: 195 mm
MB5i: 2,3 kg / 5 lbs
MB6i: 3,5 kg / 7,7 lbs
BOX SPEAKERS
i
Safety Considerations for boat installation:
Your speakers must be installed in a manner which does
not interfere with your vessel's factory installed electronic
devices. You should also take the time to securely mount
them so that they do not come loose in the event of a col-
lision or a sudden jolt to the vessel.
- Check before drilling any holes in your vessel to make
sure that you will not be drilling through the hull, a fuel tank,
a fuel line, wiring harness or other vital vessel system.
- Protect all wiring from sharp edges (metal, fibreglass,
etc.) by carefully routing them, tying them down and using
grommets and loom where appropriate.
Connection of MB5i / MB6i
Black:
To audio neg. -
Red:
To audio plus +
DLS Svenska AB
P.O. Box 13029
SE-40251 Göteborg, Sweden
Tel: +46 31 84 00 60
Fax: +46 31 84 40 21
E-mail: info@dls.se
www.dls.se
Tweeter level
Binding post of screw type.
HI
Unscrew to insert
The terminals accept 4 sq mm
/ AWG11 cable size wire.
LOW
Banana plugs can also be used.